Model 8010脈沖發生器
具體成交價以合同協議為準
- 公司名稱 北京燕京電子有限公司
- 品牌
- 型號
- 產地 美國
- 廠商性質 經銷商
- 更新時間 2017/8/20 20:31:43
- 訪問次數 725
聯系我們時請說明是化工儀器網上看到的信息,謝謝!
等離子,清洗機微小信號測量?jī)x;頻率特性分析儀;信號發生器;高速雙極型放大器;生體計測系統;濾波器;計測系統;LCR儀表;AE計測裝置;微小信號測量?jī)x;鎖相放大器;鎖相電壓表;超低噪聲放大器;前置放大器;隔離放大器;交流電源;變頻電源;仿真電源;功率放大器;可編程濾波器;低噪聲放大器
- frequency source or oscillator
- triggerable pulse source
- gate or width generator
- double pulser
- single cycle pulser
- gateable oscillator
- delay generator
- four-output pulser
a: 1 hz to 50 mhz in 8 ranges, continuously adjustable.
b: external trigger, o hz to 50 mhz.
c: single cycle by front panel pushbutton.
delay
less than 25 ns to 1 s in 9 ranges, continuously adjustable.
width
less than 20 ns to 1 s in 9 ranges, continuously adjustable.
positive output
a: normal or complement; switch se-lectable.
b: amplitude: 500 mv to 5 v continuously adjustable into 50 ohms (ttl logic).
c: rise and fall time less than 5 ns.
negative output
a: amplitude: fixed -0.8 v pulse (nim logic) into 50 ohms, or -1.5 v with base line offset of -0.5 v into 50 ohms (ecl logic); switch se-lectable.
b: rise and fall times less than 3.5 ns.
duty factor
greater than 50% each output, in complementary pulse mode duty factors larger than 90% may be attained.
trigger out
positive +1.1 v square wave into 50 ohms.
external trigger
requires positive l v, with rate of rise greater than 3 v/,us.
waveform distortion
less than 5% at full amplitude.
external gate
synchronous or asynchronous; switch se-lectable. requires a positive 1.5 v signal.
single/double pulse
switch se-lectable, minimum double pulse spacing of 20 ns. pulse separation set by delay controls.
jitter
repetition rate, delay or width, 0.1% +50 ps
mechanical
double width aec module, 2.7" wide x 8.7" high in accordance with tid-20893 (rev. 3).
weight
3 1/2 lbs., net; 7 lbs., shipping.
power requirements
a: +12 v @ 380 ma, -12 v 100 ma, or:
b: +12 v @ 80 ma, -12 v @ 100 ma, +6 v @ 300 ma, se-lectable internally. easily changed by removing side and throwing slide switch into either position.